GD55LB01GE

FEATURES

◆ 1G-bit Serial Flash ◆ Fast Program/Erase Speed

 - 128M-Byte - Page Program time: 0.18ms typical

 - 256 Bytes per programmable page - Sector Erase time: 30ms typical

 - Block Erase time: 0.1/0.2s typical

◆ Standard, Quad SPI, DTR,QPI - Chip Erase time: 100s typical

- Standard SPI: SCLK, CS#, SI, SO, WP#, RESET#

 - Quad SPI: SCLK, CS#, IO0, IO1, IO2, IO3, RESET# ◆ Flexible Architecture

 - QPI: SCLK, CS#, IO0, IO1, IO2, IO3, RESET# - Sector of 4K-Byte

- SPI DTR (Double Transfer Rate) Read - Block of 32/64K-Byte

- 3 or 4-Byte Address Mode - Erase/Program Suspend/Resume

◆ High Speed Clock Frequency ◆ Low Power Consumption

 - 166MHz for fast read - 40μA typical stand-by current

- Quad I/O Data transfer up to 532Mbits/s - 8μA typical power-down current

 - QPI Mode Data transfer up to 532Mbits/s

- DTR Quad I/O Data transfer up to 720Mbits/s ◆ Advanced Security Features

 - 128-bit Unique ID

◆ Allows XIP (eXecute in Place) Operation - 4K-Byte Security Registers With OTP Lock

 - High speed Read reduce overall XiP instruction fetch time 

- Continuous Read with Wrap further reduce data latency to ◆ Single Power Supply Voltage

fill up SoC cache - Full voltage range: 1.65~2.0V

◆ Software/Hardware Write Protection ◆ Endurance and Data Retention

 - Write protect all/portion of memory via software - Minimum 100,000 Program/Erase Cycles

 - Enable/Disable protection with WP# Pin - 20-year data retention typical

- Individual Block Protection 

◆ Package Information

- SOP16 300mil

- WSON8 (8x6mm)

 - TFBGA-24ball (5x5 Ball Array)

GENERAL DESCRIPTIONS

The GD55LB01GE (1G-bit) Serial flash supports the standard Serial Peripheral Interface (SPI), and supports the Quad 

SPI and DTR mode: Serial Clock, Chip Select, Serial Data I/O0 (SI), I/O1 (SO), I/O2 (WP#), I/O3, and RESET#. The

Quad output data is transferred with speed of 664Mbits/s, the Quad I/O data is transferred with speed of 532Mbits/s, and 

the DTR Quad I/O data is transferred with speed of 720Mbits/s.