GD25LE64E

FEATURES

◆ 64M-bit Serial Flash ◆ Fast Program/Erase Speed

 - 8192K-Byte - Page Program time: 0.4ms typical

 - 256 Bytes per programmable page - Sector Erase time: 40ms typical

 - Block Erase time: 0.15s/0.2s typical

◆ Standard, Dual, Quad SPI, QPI - Chip Erase time: 16s typical

 - Standard SPI: SCLK, CS#, SI, SO, WP#, HOLD#

 - Dual SPI: SCLK, CS#, IO0, IO1, WP#, HOLD# ◆ Flexible Architecture

 - Quad SPI: SCLK, CS#, IO0, IO1, IO2, IO3 - Uniform Sector of 4K-Byte

 - QPI: SCLK, CS#, IO0, IO1, IO2, IO3 - Uniform Block of 32/64K-Byte

◆ Low Power Consumption

◆ High Speed Clock Frequency - 10μA typical standby current

 - 133MHz for fast read - 0.2μA typical deep power down current

 - Dual I/O Data transfer up to 266Mbits/s

 - Quad I/O Data transfer up to 532Mbits/s ◆ Advanced Security Features

 - QPI Mode Data transfer up to 532Mbits/s - 128-bit Unique ID for each device

 - Serial Flash Discoverable parameters (SFDP) register

 - 3x1024-Byte Security Registers With OTP Locks

◆ Software/Hardware Write Protection

 - Write protect all/portion of memory via software ◆ Single Power Supply Voltage

 - Enable/Disable protection with WP# Pin - Full voltage range: 1.65-2.0V

 - Top/Bottom Block protection

◆ Package Information

◆ Endurance and Data Retention - SOP8 150mil

 - Minimum 100,000 Program/Erase Cycles - SOP8 208mil

 - 20-year data retention typical - USON8 (3x4mm)

 - USON8 (4x4mm)

◆ Allows XiP (eXecute In Place) Operation - WSON8 (6x5mm)

 - High speed Read reduce overall XiP instruction fetch time - WLCSP 4-4 ball array

 - Continuous Read with Wrap further reduce data latency to

 fill up SoC cache

GENERAL DESCRIPTIONS

The GD25LE64E (64M-bit) Serial flash supports the standard Serial Peripheral Interface (SPI), and the Dual/Quad SPI: 

Serial Clock, Chip Select, Serial Data I/O0 (SI), I/O1 (SO), I/O2 (WP#), I/O3 (HOLD#). The Dual I/O data is transferred 

with speed of 266Mbit/s, and the Quad I/O data is transferred with speed of 532Mbit/s.