型号:GD25LQ128E
品牌:GD
最小包装:
封装:SOP8 208mil VSOP8 208mil SOP16 300mil USON8 4x4mm WSON8 6x5mm WSON8 8x6mm TFBGA24 8x6mm (5x5 ball array) WLCSP (4-4 ball array)
数量:
产 品 说 明 | ||||||||
FEATURES ◆ 128M-bit Serial Flash ◆ Fast Program/Erase Speed - 16M-Byte - Page Program time: 0.5ms typical - 256 Bytes per programmable page - Sector Erase time: 70ms typical - Block Erase time: 0.16s/0.3s typical ◆ Standard, Dual, Quad SPI, QPI - Chip Erase time: 50s typical - Standard SPI: SCLK, CS#, SI, SO, WP#, HOLD#, RESET# - Dual SPI: SCLK, CS#, IO0, IO1, WP#, HOLD#, RESET# ◆ Flexible Architecture - Quad SPI: SCLK, CS#, IO0, IO1, IO2, IO3, RESET# - Uniform Sector of 4K-Byte - QPI: SCLK, CS#, IO0, IO1, IO2, IO3, RESET# - Uniform Block of 32/64K-Byte ◆ High Speed Clock Frequency ◆ Low Power Consumption - 120MHz for fast read with 30PF load - 35μA typical standby current - Dual I/O Data transfer up to 240Mbits/s - 1μA typical deep power down current - Quad I/O Data transfer up to 480Mbits/s - QPI Mode Data transfer up to 480Mbits/s ◆ Advanced Security Features - 128-bit Unique ID for each device ◆ Software/Hardware Write Protection - Serial Flash Discoverable parameters (SFDP) register - Write protect all/portion of memory via software - 3x1024-Byte Security Registers With OTP Locks - Enable/Disable protection with WP# Pin - Top/Bottom Block protection ◆ Single Power Supply Voltage - Full voltage range: 1.65-2.0V ◆ Endurance and Data Retention - Minimum 100,000 Program/Erase Cycles ◆ Package Information - 20-year data retention typical - SOP8 208mil - VSOP8 208mil ◆ Allows XiP (eXecute In Place) Operation - SOP16 300mil - High speed Read reduce overall XiP instruction fetch time - USON8 (4x4mm) - Continuous Read with Wrap further reduce data latency to - WSON8 (6x5mm) fill up SoC cache - WSON8 (8x6mm) - TFBGA-24ball (5x5 Ball Array) - WLCSP 4-4 ball array GENERAL DESCRIPTIONS The GD25LQ128E (128M-bit) Serial flash supports the standard Serial Peripheral Interface (SPI), and the Dual/Quad SPI: Serial Clock, Chip Select, Serial Data I/O0 (SI), I/O1 (SO), I/O2 (WP#), I/O3 (HOLD#). The Dual I/O data is transferred with speed of 240Mbit/s, and the Quad I/O data is transferred with speed of 480Mbit/s. |
CATALOGUE